Protective and decorative coatings; paints, varnishes, lacquers, and inks

249 Pages·1.323 MB·English

by  Joseph J Mattiello

UFC 3-190-06
16 January 2004

UNIFIED FACILITIES CRITERIA (UFC)

PROTECTIVE COATINGS AND
PAINTS

APPROVED FOR PUBLIC RELEASE; DISTRIBUTION UNLIMITED
UFC 3-190-06
16 January 2004

UNIFIED FACILITIES CRITERIA (UFC)

PROTECTIVE COATINGS AND PAINTS

Any copyrighted material included in this UFC is identified at its point of use.
Use of the copyrighted material apart from this UFC must have the permission of the
copyright holder.

U.S. ARMY CORPS OF ENGINEERS

NAVAL FACILITIES ENGINEERING COMMAND (Preparing Activity)

AIR FORCE CIVIL ENGINEERING SUPPORT AGENCY

Record of Changes (changes indicated by \1\ ... /1/ )

Change No. Date Location
UFC 3-190-06
16 January 2004

FOREWORD

The Unified Facilities Criteria (UFC) system is prescribed by MIL-STD 3007 and provides
planning, design, construction, sustainment, restoration, and modernization criteria, and applies
to the Military Departments, the Defense Agencies, and the DoD Field Activities in accordance
with USD(AT&L) Memorandum dated 29 May 2002. UFC will be used for all DoD projects and
work for other customers where appropriate.

UFC are living documents and will be periodically reviewed, updated, and made available to
users as part of the Services’ responsibility for providing technical criteria for military
construction. Headquarters, U.S. Army Corps of Engineers (HQUSACE), Naval Facilities
Engineering Command (NAVFAC), and Air Force Civil Engineer Support Agency (AFCESA) are
responsible for administration of the UFC system. Defense agencies should contact the
preparing service for document interpretation and improvements. Technical content of UFC is
the responsibility of the cognizant DoD working group. Recommended changes with supporting
rationale should be sent to the respective service proponent office by the following electronic
form: Criteria Change Request (CCR). The form is also accessible from the Internet sites listed
below.

UFC are effective upon issuance and are distributed only in electronic media from the following
sources:

• Unified Facilities Criteria (UFC) Index http://65.204.17.188//report/doc_ufc.html.
• USACE TECHINFO Internet site http://www.hnd.usace.army.mil/techinfo/index.htm.
• NAVFAC Engineering Innovation and Criteria Office Internet site http://criteria.navfac.navy.mil.
• Construction Criteria Base (CCB) system maintained by the National Institute of Building
Sciences at Internet site http://www.nibs.org/ccb.

Hard copies of UFC printed from electronic media should be checked against the current
electronic version prior to use to ensure that they are current.

AUTHORIZED BY:

______________________________________ ______________________________________
DONALD L. BASHAM, P.E. DR. JAMES W WRIGHT, P.E.
Chief, Engineering and Construction Division Chief Engineer
U.S. Army Corps of Engineers Naval Facilities Engineering Command

______________________________________ ______________________________________
KATHLEEN I. FERGUSON, P.E. Dr. GET W. MOY, P.E.
The Deputy Civil Engineer Director, Installations Requirements and
DCS/Installations & Logistics Management
Department of the Air Force Office of the Deputy Under Secretary of Defense
(Installations and Environment)
UFC 3-190-06
16 January 2004
CONTENTS

Page
CHAPTER 1 INTRODUCTION

Paragraph 1-1 PURPOSE AND SCOPE....................................................... 1-1
1-2 APPLICABILITY..................................................................... 1-1
1-2.1 General Building Requirements............................................. 1-1
1-2.2 Safety .................................................................................... 1-1
1-2.3 Fire Protection....................................................................... 1-1
1-2.4 Antiterrorism/Force Protection............................................... 1-1
1-3 REFERENCES...................................................................... 1-1

APPENDIX A MIL-HDBK 1110……...…………...................…………………… A-1
i
UFC 3-190-06
16 January 2004
CHAPTER 1

INTRODUCTION

1-1 PURPOSE AND SCOPE. This UFC is comprised of two sections.
Chapter 1 introduces this UFC and provides a listing of references to other Tri-Service
documents closely related to the subject. Appendix A contains the full text copy of the
previously released Military Handbook (MIL-HDBK) on this subject. This UFC serves as
criteria until such time as the full text UFC is developed from the MIL-HDBK and other
sources.

This UFC provides general criteria for protective coatings and paints.

Note that this document does not constitute a detailed technical design,
maintenance or operations manual, and is issued as a general guide to the
considerations associated with protective coatings and paints.

1-2 APPLICABILITY. This UFC applies to all Navy and Air Force service
elements and contractors; Army service elements should use the references cited in
paragraph 1-3 below; all other DoD agencies may use either document unless explicitly
directed otherwise.

1-2.1 GENERAL BUILDING REQUIREMENTS. All DoD facilities must comply
with UFC 1-200-01, Design: General Building Requirements. If any conflict occurs
between this UFC and UFC 1-200-01, the requirements of UFC 1-200-01 take
precedence.

1-2.2 SAFETY. All DoD facilities must comply with DODINST 6055.1 and
applicable Occupational Safety and Health Administration (OSHA) safety and health
standards.

NOTE: All NAVY projects, must comply with OPNAVINST 5100.23 (series), Navy
Occupational Safety and Health Program Manual. The most recent publication in this
series can be accessed at the NAVFAC Safety web site:
www.navfac.navy.mil/safety/pub.htm. If any conflict occurs between this UFC and
OPNAVINST 5100.23, the requirements of OPNAVINST 5100.23 take precedence.

1-2.3 FIRE PROTECTION. All DoD facilities must comply with UFC 3-600-01,
Design: Fire Protection Engineering for Facilities. If any conflict occurs between this
UFC and UFC 3-600-01, the requirements of UFC 3-600-01 take precedence.

1-2.4 ANTITERRORISM/FORCE PROTECTION. All DoD facilities must
comply with UFC 4-010-01, Design: DoD Minimum Antiterrorism Standards for
Buildings. If any conflict occurs between this UFC and UFC 4-010-01, the requirements
of UFC 4-010-01 take precedence.

1-3 REFERENCES. The following Tri-Service publications have valuable
information on the subject of this UFC. When the full text UFC is developed for this
subject, applicable portions of these documents will be incorporated into the text. The
1-1
UFC 3-190-06
16 January 2004
designer is encouraged to access and review these documents as well as the
references cited in Appendix A.

1. US Army Corps of Engineers AFETL 96-5, Hangar Concrete Floor
Commander Reflective Coating Criteria, 26 August
USACE Publication Depot 1996
ATTN: CEIM-IM-PD USACE EM 1110-2-3400, Painting:
2803 52nd Avenue New Construction and Maintenance
Hyattsville, MD 20781-1102 USACE TM 5-618, Paints and
[phone] fax: 0084 Protective Coatings, 15 June 1981
[email protected]
http://www.usace.army.mil/inet/usace-docs/

1-1
UFC 3-190-06
16 January 2004
APPENDIX A

MIL-HDBK 1110
PROTECTIVE COATINGS AND PAINTS
A-1
1.
NOT MEASUREMENT
SENSITIVE

MIL-HDBK-1110
17 JANUARY 1995
SUPERSEDING
NAVFAC MO-110
JUNE 1981
MILITARY HANDBOOK
HANDBOOK FOR PAINTS AND PROTECTIVE COATINGS
FOR FACILITIES
AMSC N/A AREA FACR
DISTRIBUTION STATEMENT A. Approved for public release; distribution
is unlimited.
MIL-HDBK-1110
ABSTRACT
This handbook is provided as guidance for DOD personnel wishing
to apply architectural paints or protective coatings to military
structures fixed in place. It is not for use with ships,
aircraft, or automotive vehicles. It is written for general use
by both those with much and with little knowledge of the use of
paint and coating materials. It contains information on the
composition of coatings, their mechanisms of curing,
environmental and safety concerns, necessary surface preparation,
selection for different substrates and structures, application,
inspection, and failure analysis.
ii
MIL-HDBK-1110
FOREWORD
This handbook identifies criteria and procedures for applying
architectural paints or protective coatings to military
structures fixed in place.
Recommendations for improvements are encouraged from Government
agencies and the private sector and should be furnished on the DD
Form 1426 provided inside the back cover to Commanding Officer,
Northern Division, Naval Facilities Engineering Command, Code
164, 10 Industrial Highway, Mail Stop 82, Lester, PA 19113-2090;
Telephone: Commercial [phone]/DSN 443-0661.
THIS HANDBOOK SHALL NOT BE USED AS A REFERENCE DOCUMENT FOR
PROCUREMENT OF FACILITIES CONSTRUCTION. IT IS TO BE USED AS A
MAINTENANCE MANAGEMENT TOOL BY PUBLIC WORKS DEPARTMENTS, PUBLIC
WORKS CENTERS, BASE CIVIL ENGINEERS, AND FACILITIES ENGINEERS.
DO NOT REFERENCE IT IN MILITARY OR FEDERAL SPECIFICATIONS OR
OTHER PROCUREMENT DOCUMENTS.
iii